To measure a hydraulic cylinder for replacement, identify its function and part number first, then record retracted and extended pin-to-pin length, effective stroke, bore, rod diameter, mounting geometry, pin sizes, port details and installation clearances. Measurements alone are not enough: pressure, load, speed, duty cycle and load-holding requirements also determine whether a replacement is safe and interchangeable.<\/p>\n\n\n\n
This guide is educational and does not replace the equipment manufacturer’s service instructions, lockout procedure or a qualified hydraulic technician. High-pressure fluid and unsupported machine loads can cause serious injury.<\/p>\n\n\n\n
Record the machine manufacturer, model, serial range, cylinder position, part number and drawing number. The same machine can use several cylinders that appear similar but have different forces, strokes, ports or mounting offsets.<\/p>\n\n\n\n
Photograph the complete installed cylinder from both sides. Include a scale reference and close-ups of mounts, ports, manifolds, sensors and markings.<\/p>\n\n\n\n
Measure between the functional mounting centers, usually pin center to pin center, with the cylinder fully retracted. If safe extension is possible on a controlled bench, record the fully extended center distance as well.<\/p>\n\n\n\n
Effective stroke is the change between verified retracted and extended center distances. Do not infer stroke from exposed rod length because internal stops, cushions and thread engagement affect the usable travel.<\/p>\n\n\n\n
Rod diameter can be measured on an undamaged, clean section with suitable calibrated equipment. Bore normally requires controlled disassembly or a reliable drawing; outside tube diameter does not equal bore.<\/p>\n\n\n\n
When the cylinder is being replaced rather than rebuilt, force requirements and system pressure may be more useful than an uncertain bore measurement. Keep unverified values clearly marked as open.<\/p>\n\n\n\n
For clevis, eye, trunnion, flange or cross-tube mounts, record pin diameter, lug width, clevis gap, bearing type, offset, orientation and grease provisions. Measure both ends independently.<\/p>\n\n\n\n
Record port thread standard, nominal size, sealing method, clock position, axial location and orientation. Include any integrated counterbalance valve, manifold, test port or sensor.<\/p>\n\n\n\n
Provide normal and peak pressure, required push and pull force, travel speed, cycle frequency, side-load exposure, load-holding behavior, hydraulic fluid and operating temperature.<\/p>\n\n\n\n
Also document dust, water, salt, chemicals, impact and storage conditions. These inputs influence rod, seals, wipers, coatings and validation tests.<\/p>\n\n\n\n
| Measurement<\/th> | How to record it<\/th><\/tr><\/thead> |
|---|---|
| Retracted length<\/td> | Mounting center to mounting center at confirmed full retraction<\/td><\/tr> |
| Extended length<\/td> | Mounting center to mounting center at confirmed full extension<\/td><\/tr> |
| Accident vasculaire c\u00e9r\u00e9bral<\/td> | Verified difference between extended and retracted center distances<\/td><\/tr> |
| Diam\u00e8tre de la tige<\/td> | Clean undamaged rod area; state tool and unit<\/td><\/tr> |
| Mounts<\/td> | Type, pin diameter, widths, offsets, bearing and orientation at both ends<\/td><\/tr> |
| Ports<\/td> | Thread, size, seal, position, orientation and attached valves<\/td><\/tr><\/tbody><\/table><\/figure>\n\n\n\nInformation to record for an engineering review<\/h2>\n\n\n\nFrequently asked questions<\/h2>\n\n\n\n |